一開始放入coppeliasim開啟動力學特性後,零件就會全部解體,因此在修改一次圖檔
組合圖
再組合時面和面應要留有間隙避免發生干涉
在銷前加入檔板,防止零件滑出
滑軌
將滑軌溝槽高度改為1.5mm,避免模擬時產生干涉
零件載點:https://40823218.github.io/stage1-bg5/content/0313.html
Copyright © All rights reserved | This template is made with by Colorlib